Setup for 4mm ID/6mm OD Bowden Tube (Ultimaker) (Q91570)

From Library of Open Source Hardware
Jump to navigation Jump to search
No description defined
Language Label Description Also known as
English
Setup for 4mm ID/6mm OD Bowden Tube (Ultimaker)
No description defined

    Statements

    I had a problem with my original tube, it was a slightly small diameter and even the stock Ultimaker PLA wouldn't pass through it. I obtained a new PFA tube and ran into issues getting it to hold it in both ends tight enough (the original bowden tube is slightly larger on the outside). Hoping these instructions save you that grief! :D As an added bonus the new tube is way less finicky about filament thickness.
    0 references
    https://spdx.org/licenses/CC-BY-SA-4.0
    0 references
    www.thingiverse.com
    0 references
    en
    0 references
    auto
    0 references
    thingiverse.com
    0 references
    0 references
    1.0.0
    0 references
    futurejames
    0 references