80mm Fanholder (Q743851)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
80mm Fanholder
|
No description defined
|
Statements
thingiverse.com
0 references
www.thingiverse.com
0 references
joeyphunk
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
I wanted a simple way to mount a fan on my solidoodle3, but finding an elegant design was tough because i had an e3d hotend installed. In desperation i put a magnet on a screw in the corner of an 80mm fan that i had directly wired to a 12v power supply and stuck it to the x axis rods where it sticks out the end of the carriage - and it worked! With this in mind i created a very simple holder than uses 4 8mm magnets and two screws and 2 nuts. There is not gluing required; everything can be disassembled if you don't like it! This design also cools one of the motors.
0 references
en
0 references
1.0.0
0 references
auto
0 references