Gyro Eval Board Holder (Q66099)

This OpenSCAD script creates a holder for an STM Gyro Eval Board that fits onto the moutign holes on a Gyro_Turntable_Mounting_Plate so that it can be tested on a high speed turntable Note: may need to trim some stuff from the top of the cylindrical posts as there are many small components adjacent to the screw holes Changes from previous versions: v0.4 - removed one of the bolt holes under devices - make it thicker (from 3 to 5 mm) so it prints better v0.3 - adjusted some values based on callipers based measurements of board - now it should be realistically sized v0.2 - removed junk lines - added cutouts - repositioned parts - added minkowski sum to round out corners under PCB - made it into a printable item v0.1 - first attempt at laying out parts