Canon IXUS 70 battery adapter (Q51360)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
Canon IXUS 70 battery adapter
|
No description defined
|
Statements
macsimski
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
thingiverse.com
0 references
auto
0 references
to use an external power supply. there is a small rubber cover in the hinged door of the camera. underneath sits a 6mm hole where the cable can go trough. Use a VERY small connector. i strip the cable for about 5cm and tin it completely. then I begin on the bottom and bending them around the edge. negative/black goes near the corner, positive/red to the center. You have to measure a few times so the stripped part ends near the big hole. there you can make a knot. bond the tinned wires to the case with a soldering iron. then apply 4.3 volts, 1A minimum to the wires and you are up and running. ver date comment 1.0 03-09-2011 initial version 1.1 03-09-2011 increased curve resolution 1.2 04-09-2011 used union() initial print 1.3 10-09-2011 corrected round holes. output hole smaller, bottom of big hole thicker, increased small hole size for the contact wire
0 references
1.0.0
0 references
en
0 references
www.thingiverse.com
0 references