Automated Belt Attachment (Q41910)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
Automated Belt Attachment
|
No description defined
|
Statements
www.thingiverse.com
0 references
en
0 references
thingiverse.com
0 references
1.0.0
0 references
https://spdx.org/licenses/CC-BY-4.0
0 references
auto
0 references
I kept having problems with big prints shifting on the automated build platform, and I heard it might be because the belt isnt completely attached to the platform. So what I did was create flaps that went over the belt to keep it from moving upward during a print. I have attached them, but have yet to print out a large object. (Also, I have only printed out the middle ones for use, but I also made ones to go on the corners) I have prints for the middle screws, BLFR (Back-left, Front-right), and BRFL (Back-right, Front-left). Print whichever ones you want depending on where you want to attach the flaps. NOTE: These flaps COVER PART OF THE BUILD PLATFORM. While it is a very small amount, make sure your prints are small enough that the extruder wont run into these. EDIT: Someone mentioned that this might stick to the belt after awhile because of the heat. If this happens to me, I will be sure to post it. Also, because the build platform doesn't get as high as the extruder does, only around 125C, I believe it should be fine. Only concern I would have is it might eventually warp from heating/cooling alot.
0 references
bongoboy23
0 references