bed-spring_4off (improved) (Q36174)
Jump to navigation
Jump to search
No description defined
| Language | Label | Description | Also known as |
|---|---|---|---|
| English |
bed-spring_4off (improved)
|
No description defined
|
Statements
en
0 references
bed-spring_4off from the RepRap Mendel has a very short area behind the teardrop that causes the part to fail if the filament does not stick perfectly. I made that area somewhat longer to improve print-reliability. The provided photo of this failure was done on a properly calibrated RepMan with 0.25mm layer-heigh and usualy extremely good prints. So I guess this issue is much worse on the majority of RepRaps and Makerbots.
0 references
1.0.0
0 references
auto
0 references
thingiverse.com
0 references
MarcusWolschon
0 references
www.thingiverse.com
0 references
https://spdx.org/licenses/GPL-3.0-or-later
0 references