PCB Holder Mrk II. (Q34914)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
PCB Holder Mrk II.
|
No description defined
|
Statements
I was inspired by zignig's Printable Desk Clamp http://www.thingiverse.com/thing:683 . I used hex nuts instead of square nuts because hex nuts are more common. All the parts are easily available at hardware stores and hobby shops. The total cost is about $4.50 for this clamp compared to $50 ones. It is used for holding circuit boards at comfortable angles, hobby modeling, and holding stuff. Enjoy. The picture of all parts does not show two nuts that I had already hammered in but I did not want to take them out. Also it does not show 20mm brass tubing as I already hammered some of them in.
0 references
en
0 references
thingiverse.com
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
auto
0 references
1.0.0
0 references
www.thingiverse.com
0 references
vietor
0 references