Difference between revisions of "Setup for 4mm ID/6mm OD Bowden Tube (Ultimaker) (Q91570)"
Jump to navigation
Jump to search
(Reconciliation Edit) |
(Added [en] label: Setup for 4mm ID/6mm OD Bowden Tube (Ultimaker)) |
||
| label / en | label / en | ||
| + | Setup for 4mm ID/6mm OD Bowden Tube (Ultimaker) | ||
Latest revision as of 12:31, 27 February 2022
No description defined
| Language | Label | Description | Also known as |
|---|---|---|---|
| English |
Setup for 4mm ID/6mm OD Bowden Tube (Ultimaker)
|
No description defined
|
Statements
I had a problem with my original tube, it was a slightly small diameter and even the stock Ultimaker PLA wouldn't pass through it. I obtained a new PFA tube and ran into issues getting it to hold it in both ends tight enough (the original bowden tube is slightly larger on the outside). Hoping these instructions save you that grief! :D As an added bonus the new tube is way less finicky about filament thickness.
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
www.thingiverse.com
0 references
en
0 references
auto
0 references
thingiverse.com
0 references
1.0.0
0 references
futurejames
0 references