No label defined (Q91459)

UPDATE: im working on a new version of this with some improvements in terms of fit that will incorporate all thoughts from this object, corrected measurements and design-refinement for those of you who can't wait (the cad files are ready just not verified by print) please use Aggresives parts in the meantime i gave them a shot and they made me realice i realy need to improve my version! -> linke to Aggresives Version http://www.thingiverse.com/thing:27945 If you can wait one or two days check back here, ill post the new part refference here These are replacement holders for the X and Y (and Z but in my eyes not necessary) axis of the Orca 0.40 and 0.42 Linear Bearings. After a few weeks with the LM8UU linear bearings i just couldn't stand the rattling (noise) any more. I had lubed them several times with grease and with oil none brought improvement. A good tip was to mount them so that always 2 ball lines run on the smooth rood (45° X alignment) but i still had rattling. So i first went for the printed LM8UU which really eased my pain (http://www.thingiverse.com/thing:16813) . Next logical step were IGUS slide bearings but they have a different outer diameter an length than the LM8UU so the original holders won't fit. These holders should snap tightly to the RJMP 01-08 bearings and won't fall off during mounting (part that annoyed me on the original LM8UU holders). I've been printing with them now for a week and i love them. Happy more silent Printing ;) Update: Here's a video of them in action http://youtu.be/on6PA-QSfIc