No label defined (Q910105)

Our host site has carefully concealed the cup feeder part over on the other side, thingiview rotate to unhide. Make sure to see the instructions tab or else your print will be a 2kg door stop! There is some minor post processing to do. This creation is a storage container with holes only at the bottom. Fill it with water, using a tube from your tap if necessary and then gently tip it pointy side up and place for your pets to drink from. I will be doing a version of this using less plastic, but I like the aesthetics of it. Probably best to print in clear PLA and leave out of the direct sun else your pet will get warm water and evaporation may push some water out.