No label defined (Q744757)

From Library of Open Source Hardware
Revision as of 10:26, 5 May 2022 by Aisberg (talk | contribs) (Reconciliation Edit)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
No description defined
Language Label Description Also known as
English
No label defined
No description defined

    Statements

    0 references
    This is to space out short stock for turning or facing operations in a 3-jaw lathe chuck. It flexes over the jaws to take up 3/4" of space. There is a center hole which could be threaded for a stud/bolt to further space stock outward if needed and 3 holes for set screws for finer adjustment if needed for leveling (Magnets could be pressed into these to hold it to the body of the chuck). The center of this naturally takes up space so the minimum grip diameter possible is about 5/8" diameter. This is sized to fit jaws which are 3/4" wide and designed to flex and grip lightly. On a chuck with narrower jaws (I have tried it on a 5" chuck that had about 5/8" wide jaws) this is loose but does not rattle excessively at speed with a part against it. This shape is rather bizarre when viewed out of context but it works quite well on a 6" 3-jaw Chuck.
    0 references
    kencaid
    0 references
    1.0.0
    0 references
    thingiverse.com
    0 references
    en
    0 references
    auto
    0 references
    https://spdx.org/licenses/CC-BY-SA-4.0
    0 references
    www.thingiverse.com
    0 references