No label defined (Q59058)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
No label defined
|
No description defined
|
Statements
thingiverse.com
0 references
I was a victim of the dreaded "Leak down chair". I flipped it over to get the lay of the land. The cylinder was 1" diameter, so a quick trip to the band saw with a piece of 1" I.D. PVC pipe was in order. I sliced a 2" long piece and then split it. Quick work on the band saw. Attached with a couple of zip ties. The first was a little too short. I made a 2 1/2" and a 3". Installed the 3" and it seemed just right. I used 3 zip ties, but didn't cut them, in case I need to snug them up later. I thought it would need heater hose clamps, but the zip ties are holding OK. I then drew it up so it can be 3D printed. This part is 1.125" I.D.
0 references
ronthomp
0 references
1.0.0
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
www.thingiverse.com
0 references
auto
0 references
en
0 references