No label defined (Q54786)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
No label defined
|
No description defined
|
Statements
Here is the STL file, I've unfortunately accidentally deleted the SCAD file, will have to start over again. The bottom (lower) part is screwed on the threaded rod (open M8 nut inside, one M8 washer and one M8 nut below). The top (higher) part is screwed on the motor shaft with one M3 nut and one M3x10 screw. Both parts are attached with 4 M3 nuts and 4 M3x10 screws. With this design it should be possible to assemble/disassemble multiple times without damaging the printer parts. Warning: I haven't printed these parts yet.
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
1.0.0
0 references
en
0 references
auto
0 references
www.thingiverse.com
0 references
thingiverse.com
0 references
devijvers
0 references