No label defined (Q60036)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
No label defined
|
No description defined
|
Statements
www.thingiverse.com
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
granz
0 references
1.0.0
0 references
en
0 references
auto
0 references
I wasn't very happy with the standard Prusa Y motor mount due to it's lack of rigidity (I used a cable tie on the back of the motor for extra support until now.) Since I am running Synchromesh Cable now and not belts (see http://www.thingiverse.com/thing:15923 ) and the cable is so thin I figured there was no need for an idler pulley above the motor. This eliminates one bearing and some nuts and washers and also helps your pulley get a better grip on the cable because it wraps 3/4 around rather than about 1/2 with the original motor mount.
0 references
thingiverse.com
0 references