Ultimaker XY rods-timingbelt alignmenttool (Q46797)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
Ultimaker XY rods-timingbelt alignmenttool
|
No description defined
|
Statements
auto
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
en
0 references
1.0.0
0 references
www.thingiverse.com
0 references
Berend
0 references
thingiverse.com
0 references
Two little tools to see if your Ultimaker XY guiding rods timing belts are correctly aligned according to the 'sliding blocks' The optimum is that the timing belt of the X -rod has no Y component, so the 2 pullies and the 'sliding block' must be in the same Y-plane. This should reduce mechanical stress in the system and gives a more balanced load for the belts/pulleys. It can be difficult to see if the pulley is mounted straight above/below the rods. The tool has a complexity/added value ratio of 1 (It can boost your Ultimaker performance with at least 0.000005%)
0 references