LaserUnicorn (Q43497)
Jump to navigation
Jump to search
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
LaserUnicorn
|
No description defined
|
Statements
A Unicorn-compatible mount for the same laser pointer as in the LAZOR mount thing. The LAZOR mount is technically an ancestor of this design, as I used that base as a starting point when designing this. Includes a mount for a micro servo and a flag to block the laser beam. This should be compatible with the unicorn firmware & hookup. I haven't assembled yet, but I think the pen down angle will be 60 and the pen up angle will be 0. Only printable on a MENDEL!!!! The base is 14+ cm wide! Also, it'll print much better with the smaller features on a stepstruder! UPDATE: we test mounted this at my local makerbot club's meeting this Monday. The mounting holes are a little too close for the makerbot z-stage, we ended up using some tape to do the test. Will change and update in the near future, in the meantime I can confirm this works! Smoking's bad for you. And bad for your makerbot. But it sure did help me get the laser aimed here: Calibration: http://www.youtube.com/watch?v=ilOzZ1QDx7A In action: http://www.youtube.com/watch?v=722YzYM8xuY
0 references
en
0 references
auto
0 references
merlinjim
0 references
1.0.0
0 references
https://spdx.org/licenses/CC-BY-4.0
0 references
www.thingiverse.com
0 references
thingiverse.com
0 references