Housing for Thermal Safety Cutoff Switch (Q58035)

I just built my ToM and I'm still experimenting with it. I made this enclosure for the safety cutoff switch on my ToM, because I don't like the way it looks just hanging there with wires running everywhere. There are 2 parts to this enclosure, and they snap together (with some cleaning needed on my print (and most likely yours) even though I included a 0.05mm clearance all around the joining faces). No modification of the switch is required. The base simply replaces the 2 spacers. The top cap just snaps on & the LEDs slide right inside of the top cap. NOTE: My design has "NORMAL" and "FAULT" engraved in the top of the case, in very small letters. This DID NOT show up in my print, and doesn't show up in the .STL file. I imagine the resolution of the lettering is too small for Skeinforge to handle? The engraved lettering "SAFETY CUTOFF" showed up just fine in my print... although since they were at the bottom of my print (with a raft), the bottoms of both parts warped & did not print very well (thus not shown in my photos, LOL). The insides of both parts look much better than the outsides. I don't think this is dues to design errors... I believe it to be in Skeinforge setting errors. This design was based on digital caliper measurements of the Generation 4 cutoff switch. I designed it to require no modification to the MakerBot-supplied circuit-board, or any part of the ToM itself. I have not yet fitted my housing on my thermal safety cutoff switch, so PLEASE let me know if this design needs any changes. And I would also love to see any adaptations/modifications to this design, as well as photos of any successful builds of the unmodified object... or "thing". Thanks! P.S.--As of 12-31-2011, I still haven't mounted my Safety Cutoff Switch inside this housing, because I'm still not happy with the way it looks (tons of voids in the bottom halves of both pieces, which were both printed face-down (on a raft). I'm also still not happy with the overall quality of most of my prints. But I've posted a print as of today, to show you my print results.