Difference between revisions of "LaserBeamTarget (Q48354)"
Jump to navigation
Jump to search
(Reconciliation Edit) |
(Added [en] label: LaserBeamTarget) |
||
| label / en | label / en | ||
| + | LaserBeamTarget | ||
Latest revision as of 17:59, 25 February 2022
No description defined
| Language | Label | Description | Also known as |
|---|---|---|---|
| English |
LaserBeamTarget
|
No description defined
|
Statements
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
1.0.0
0 references
www.thingiverse.com
0 references
thingiverse.com
0 references
Takeaway3DTech
0 references
auto
0 references
Laser beam Target to fit a Universal M300 laser to align the laser beam. The Laser I have is an old > 10 years used laser cutter The problem seen was push fit bearing holes were not straight so bearings did not fit vertical to the board surface see pic of single bearing. I noticed that the Lense assembly had a secondary counter bore around the laser hole made a target to fit the counter bore to alow laser alignment using the red spot laser / Lid open mode. Push fit bearings now sit parallel after laser adjustment using the target
0 references
en
0 references