Difference between revisions of "Close Tolerance Open Access Belt Fender (Q46218)"
Jump to navigation
Jump to search
(Reconciliation Edit) |
(Added [en] label: Close Tolerance Open Access Belt Fender) |
||
label / en | label / en | ||
+ | Close Tolerance Open Access Belt Fender |
Latest revision as of 16:55, 25 February 2022
No description defined
Language | Label | Description | Also known as |
---|---|---|---|
English |
Close Tolerance Open Access Belt Fender
|
No description defined
|
Statements
thingiverse.com
0 references
https://spdx.org/licenses/CC-BY-SA-4.0
0 references
auto
0 references
www.thingiverse.com
0 references
I needed a bit more room on my print bed and the only thing preventing that was the fender washers on the Y bearings. The Y carriage was bumping into them so I decided to replace them with flat sided ones. This is my first "real" part here on thingiverse. So I hope someone actually uses it and likes it. Thanks for any constructive feedback. Ver 1 was too big! (60mm diameter) Ver 2 slot seems a bit small. Ver 3 Should just end on the flat side right next to the 608 bearing, Added a couple of clips that might help. Ver 4 Removed one of the clips, lowered the height to just under 2mm
0 references
en
0 references
mrjohn
0 references
1.0.0
0 references